Used PEL washing machines in Islamabad & Rawalpindi
Is a used PEL washing machine worth buying?
PEL builds its washing machines in Lahore alongside its refrigerators and air conditioners, and sells them through a national dealer network with authorised service in both cities. That is the practical difference from a purely commodity twin tub: a service call can be booked against the model number on the plate, and common wear parts sit on shelves as well as at PEL counters.
Made or assembled in Pakistan
Spares are widely stocked locally and most technicians in the twin cities have worked on these, so common faults are usually economic to repair.
PEL washing-machine parts are carried by the same dealer network that supports its refrigerators and air conditioners, and routine items — motors, timers, belts, pulsators, capacitors — are also ordinary stock at independent shops in both cities. Control boards for automatics are ordered against the model number.
Washing Machines in stock now
Our current washing machines, across all brands — ask us on WhatsApp if you want PEL specifically.
NewAutomatic Haier Washing Machine 7 kg, 8 kg Brand New
Good UsedAsia
Good UsedDawlance DWT-250C TangleFree fully automatic top-load washing machine
For Parts / RepairSamsung washing machine
Checking a used PEL washing machine
These are specific to PEL. The general washing machines checks apply too and are on the washing machines page.
Read the Pak Elektron plate
PEL machines carry a rating plate naming Pak Elektron Limited along with the model number, and that number is what the dealer network and PEL's service counters order against. Photograph it before the machine is moved; wash areas are hard on stickers, and a missing plate leaves you with whatever a shop can fit by eye.
Ring the service line
Because PEL runs authorised service in both cities, you can quote the model number and ask what a visit and a given part would cost before you buy. Ask specifically whether that number is still supported rather than assuming it is, and get the answer before you agree anything.
Listen for a humming motor
Test the spin motor cold, from a standstill. One that hums but will not start, or needs a nudge to get going, is usually its capacitor — a cheap item carried by PEL counters and independent shops alike, so it is a deduction rather than a write-off, but it should be priced in.
Spin the basket by hand
Turn the empty spin basket by hand and watch the rim against the tub lip. A basket running out of true has been out of balance for a long time, and on these machines that wears the spin bearing — a stocked PEL part, so again a repair to price rather than a reason to stop.
What PEL washing machines are worth
- PEL machines can be booked in for branded service in both cities, so a used one with a legible plate and a dealer trail carries a route to repair that an unbadged machine does not, and buyers pay for the route as much as the machine.
- Because the machines are built locally alongside PEL's other appliances, routine wear parts — belts, pulsators, capacitors, timers — are shelf items, so a mechanical fault is a deduction rather than the end of the machine.
- On PEL automatics the control board is ordered against the model number while the mechanical parts are not, so an electronic fault pulls value down further, and the deduction tracks the wait as much as the part.
Model lines you will see second-hand
- PEL twin tubs
- PEL single-tub washers
- PEL fully automatic washing machines
General washing machines checks
These apply whatever the badge on the front says — the washing machines page covers them in full.
Spin the empty drum
With the machine off, turn the drum through a full rotation by hand. It should move smoothly and quietly. A rumble, a grinding note or side-to-side play means worn drum bearings, and on most front loaders the tub has to come apart to reach them, which rarely makes sense on a used machine.
Run a cycle with water
Ask for a rinse-and-spin with the machine actually filling. Watch that it takes water at a reasonable rate, drains fully, and reaches full spin without walking across the floor. Slow filling is usually a clogged inlet filter; refusing to spin with a wet load is often a worn belt, coupler or motor.
Fold back the door seal
On a front loader, peel the rubber boot back all the way round. Black mould in the folds is cleanable. Tears, splits or a seal that has been patched with adhesive are not, and a compromised boot leaks onto the floor at every wash.
Test the spinner separately
On a semi-automatic, the spin tub has its own motor and a lid interlock. Load it with a wet cloth and run it. Heavy vibration, a screech at start-up, or a spinner that keeps turning with the lid open are all faults, and the last one is a safety problem rather than an inconvenience.
Open the pump filter
Undo the filter at the front and look at what comes out. Grit and hair are normal. A cracked filter housing, or a drain hose with a taped repair, tells you the machine has been leaking, and water stains under the base panel are worth more than any verbal assurance.
Step through the programmes
Select each programme and confirm the machine changes what it actually does, not just what the display shows. An error code that clears when the machine is unplugged and returns mid-cycle points at the control board, which is the second expensive repair after bearings.
PEL washing machines — questions
Can you get parts for an older PEL washing machine?
Can PEL service a washing machine bought second-hand?
Other washing machines brands
Selling one instead? We buy used PEL washing machines for cash.