0340 1417862Book Help →
IslamabadSalePurchase logoIslamabadSalePurchase
We sell

Used & new Office Furniture for sale in Islamabad & Rawalpindi

Where can I buy used office furniture in Islamabad?

Used office furniture is judged on the mechanism, not the covering. On a revolving chair the parts that decide it are the gas cylinder, the five-star base and the tilt; on a desk it is the edge banding and the screw fixings under the top. A chair graded For Parts / Repair is worth taking only for its castors, and delivery across both cities covers desks that will not go in a car.

What to check before buying a used office furniture

These are the checks that set the condition grade on anything we list — and the ones worth running yourself wherever you buy.

Sit and watch the height

Set the chair high, sit down with your full weight and stay there a minute or two. A gas cylinder on its way out sinks slowly and steadily. Cylinders are a standard part matched by taper and stroke length, so it is a fix rather than a write-off, but it is the fault to expect on any used revolving chair.

Turn the chair upside down

Look at the five-star base where each arm meets the hub, especially on nylon bases, for hairline cracks that open under load. Then spin every castor; a seized one scores floors and is usually just hair wound round the axle.

Work the tilt and its lock

Rock back, lock the tilt upright, and wind the tension knob from one end of its travel to the other. A tilt that will not lock, or a knob that spins without changing anything, means the mechanism is finished, and on most chairs it is riveted to the seat pan.

Press the mesh back flat-handed

Push into the middle of a mesh back with an open palm. Sound mesh springs back evenly. A sagging pocket, or fraying where the fabric is clamped into the frame edge, means the mesh has stretched, and it cannot be re-tensioned on most models.

Check the desk underside

Look under the melamine top at the edge banding, around the cable grommet, and at the screw fixings into the leg frame and modesty panel. Swollen board along a screw line means the desk has already been taken apart and re-fixed once, and it will not hold a third time.

Load a filing cabinet drawer

Pull each drawer right out with weight in it. Runners should not sag or grate at full extension, only one drawer should open at a time if the anti-tilt interlock still works, and the keys should be with the cabinet, since replacements are cut from a code on the lock face.

Brands we see most

These are the office furniture brands that come up most often in the Islamabad and Rawalpindi second-hand market. We trade others too — this is what typically turns up, not a list of what is in stock today.

Buying used office furniture — frequently asked questions

Our office chairs keep sinking. Is it worth replacing the cylinders before selling?

Usually not, as long as the fault is declared. A sinking chair points at the gas cylinder, a standard part matched by taper and stroke length that a buyer of a lot will change in a batch. What actually lowers the grade is a cracked base or a dead tilt mechanism, since those are model-specific and often not worth sourcing.

Are workstation partitions and cubicles worth selling second-hand?

Only as a complete system. Screen panels are built to join their own family of connectors, so a stack of panels with no posts, feet, top caps or cable trays cannot be assembled into anything. Photograph one fully built bay and one panel with its fittings laid out, and count connectors as carefully as panels before sending pictures on WhatsApp.

Is it better to sell an office as one lot or piece by piece?

One lot, in almost every case. Office furniture is bought by people fitting out a whole room, so matched chairs, desks from the same range and cabinets in one finish are worth more together than apart. Splitting a floor into singles leaves odd items behind that are slow to move and awkward to collect afterwards.

More on office furniture

WhatsAppCallBrowse stock