Used & new Heaters & Geysers for sale in Islamabad & Rawalpindi
Where can I buy used heaters & geysers in Islamabad?
In this category a checked unit means more than switched on: the burner has been lit and watched, the flue collar and front guard are present, and a storage geyser has been filled and left standing to prove the tank holds. Used appliances carry the fifteen-day checking warranty. Anything gas-fired should still be connected by a competent fitter and run in a ventilated room.
What to check before buying a used heaters & geysers
These are the checks that set the condition grade on anything we list — and the ones worth running yourself wherever you buy.
Look at the flame
Light a gas geyser or room heater and watch the burner for a full minute. Steady blue cones with clean edges are right. Yellow, lazy or lifting flames, or black soot on the burner shield and the ceramic plaques, mean incomplete combustion from blocked jets or a wrong air mix — a servicing job at best and a safety matter at worst.
Drain water from the base
Open the drain valve at the bottom of a storage geyser and catch a jugful. Clear water is fine. Brown water, rust flakes or grit means the inner tank is corroding from the inside, and once a tank has begun to perforate no patch holds for long. Water that no longer stays hot as long as it used to points the same way, because sediment has filled the tank floor.
Check the flue and diverter
On a gas geyser, look where the flue pipe meets the hood. Rust flaking off the collar, or soot smudged around the draught diverter and on the wall above it, says exhaust has been spilling into the room instead of going up the pipe. That is a fitting fault rather than a machine fault, but it tells you how the unit has been run.
Watch the pilot after lighting
Hold the control knob in, light the pilot, then release it. A pilot that dies every time usually means a tired thermocouple or a dirty pilot jet, both inexpensive. Confirm which it is before agreeing anything, because on some models the same symptom comes from a failing gas valve, which is a different repair altogether.
Check the radiator seams
On an oil-filled radiator, warm it through, then run a hand along the fin seams and the bottom edge, looking for weeping oil or a greasy film that has trapped dust. These are filled and sealed at the factory: a leaking one cannot sensibly be topped up, and it will smoke off the element as the level drops.
Check the element and earth
An electric geyser that takes far longer than it should to heat normally has an element buried in scale, which is common with the hard water here. Look at the plug top and cord for melting at the pins, confirm the appliance has a proper earth, and on a fan or halogen heater make sure the guard and the tip-over switch both work.
Brands we see most
These are the heaters & geysers brands that come up most often in the Islamabad and Rawalpindi second-hand market. We trade others too — this is what typically turns up, not a list of what is in stock today.