Sell your used PEL shop & restaurant equipment in Islamabad
Who buys used PEL shop & restaurant equipment in Islamabad?
Two things move the offer on a used PEL. Whether the compressor is the original one, since a replacement fitted outside the dealer network usually ends any remaining factory cover and changes how the cabinet pulls down; and whether the invoice and warranty card still exist, because they are what a PEL dealer works from. Have the lid keys, shelves and baskets with it.
Get your cash offer
Tell us the model and condition, or send photos on WhatsApp instead.
Made or assembled in Pakistan
Spares are widely stocked locally and most technicians in the twin cities have worked on these, so common faults are usually economic to repair.
PEL manufactures in Lahore and sells through a long-established appliance dealer network in both cities, so thermostats, relays, fan motors, gaskets and door furniture are ordinary orders at a general appliance counter rather than a commercial refrigeration supplier. Inverter control boards and model-specific glass, shelves and baskets are ordered against the model code.
What your PEL shop & restaurant equipment is worth
Condition decides most of it, but these are the brand-specific things that move an offer up or down.
- PEL's appliance dealer network in Islamabad and Rawalpindi is broad enough that a used cabinet can be quoted at an ordinary appliance counter rather than a specialist refrigeration supplier, and that reach is what supports resale.
- A PEL cabinet that can be shown to be the shop-duty model rather than the household one sells more easily, because the next buyer is not guessing what the hinges, gasket and fan were rated for.
- Inverter models turn on the board: a healthy control board carries the value, and a board fault is priced against a model-specific order rather than a counter part.
- Remaining compressor cover only counts if the invoice and card travel with the cabinet, since a dealer cannot act on the plate alone.
When we can only offer parts value
- A sealed refrigeration system that has been opened and re-brazed repeatedly and still will not hold its charge is a parts unit rather than a working chiller.
- Rust that has eaten through a food-contact surface or a chiller's inner liner cannot be cleaned back to a hygienic finish.
- Coolers carrying a beverage company's branding are normally supplied to the shop on loan and remain that company's property, so they cannot be sold on.
- Cracked burner castings or a gas manifold that leaks at the joints make a range unsafe to put back into service as it stands.
What raises the price on any shop & restaurant equipment
Brand aside, these move every offer — the shop & restaurant equipment page has the rest.
- Refrigeration running on its original sealed system is worth far more than a unit whose pipework carries several brazed repair patches.
- Completeness decides a lot, because mixer bowls and hooks, oven trays and racks, fryer baskets and chiller shelves are made for one model and are difficult to replace.
- Gas equipment jetted for the supply it will actually run on places more easily, since a range set up for cylinder LPG needs its jets and regulator changed before it will burn properly on a piped connection.
- Heavier-gauge stainless steel with sound welds and no pitting around sinks and drains holds value that a thin, dented cabinet does not.
- Refrigeration and prep furniture built to standard gastronorm pan sizes takes off-the-shelf inserts and shelving, while a one-off fabricated counter needs every pan and shelf made to fit it.
Selling a PEL shop & restaurant equipment — questions
Does a used PEL freezer still carry any compressor warranty?
Is every PEL freezer in a shop a commercial model?
We also buy these shop & restaurant equipment
Looking to buy rather than sell? See what to check on a used PEL shop & restaurant equipment.