Used & new Water Dispensers & Coolers for sale in Islamabad & Rawalpindi
Where can I buy used water dispensers & coolers in Islamabad?
A checked second-hand dispenser is one that has been left running long enough for the cold tank to genuinely chill and the hot tank to reach temperature, with the base and rear panel examined for the white mineral crust that marks a slow leak. Condition is published against the four grades used across the site, used appliances carry the fifteen-day checking warranty, and delivery covers Islamabad and Rawalpindi.
What to check before buying a used water dispensers & coolers
These are the checks that set the condition grade on anything we list — and the ones worth running yourself wherever you buy.
Check how it cools
A compressor dispenser cools the way a fridge does and will bring water to a properly cold drinking temperature; a thermoelectric one uses a solid-state plate and only takes the edge off. Look behind the cabinet for a small black cylinder and warm coils, then fill the tanks, switch the cold side on and come back after twenty minutes. Merely cool water after that long means lost gas or a failed plate.
Test the hot tank
With water in the tanks, switch the hot side on and wait around ten minutes; the indicator should cycle and the red tap should give water hot enough to steam. Nothing at all usually means a burnt element or a tripped cut-out, and a tank thick with scale gives a slow, spitting flow.
Look for crust and rust
Pull the drip tray and look underneath and at the rear panel below the taps. A white mineral bloom, rust streaks or a stained cabinet floor means a slow weep that has been running a while. On most dispensers the cold tank is foamed into the cabinet, so a seam leak means stripping the machine rather than tightening a joint.
Work every tap
Press each tap fully and release it. A tap that keeps dripping after release has a perished washer, which is cheap to put right but tells you how much use the unit has had. Check the tap bodies and levers for cracks, and on push-button models make sure the button springs back rather than sticking in.
Open the bottle seat
Inspect the seat and probe the bottle sits on for cracks and for a hardened, dirty seal, since that is where most contamination gets in. Open the storage or refrigerated compartment door, work the hinge and check the gasket; on a compressor model a compartment that never gets cold points at a blockage in the cooling circuit rather than a door problem.
Look inside a deck cooler
On a steel electric cooler, lift the lid and look at the coil and tank walls. Water in both cities is hard, and heavy scale on the coil slows cooling badly, though it can be scrubbed off. Rust blooming along the base seam of the outer cabinet is more serious than surface rust on the side panels, because the base is what carries the weight of a full tank.
Brands we see most
These are the water dispensers & coolers brands that come up most often in the Islamabad and Rawalpindi second-hand market. We trade others too — this is what typically turns up, not a list of what is in stock today.