Used Millat fans & air coolers in Islamabad & Rawalpindi
Is a used Millat fans & air cooler worth buying?
Millat has made fans in Gujrat for decades, so used units span several generations of a ceiling fan that looks much the same from the floor. Working out which generation you have matters more than the age itself, because blade sets, covers and down-rods are not always common across them, and the die-cast body will outlast the winding several times over.
Made or assembled in Pakistan
Spares are widely stocked locally and most technicians in the twin cities have worked on these, so common faults are usually economic to repair.
Any winder in Rawalpindi will rewind, re-bush and rebalance a Millat, and capacitors and regulators are counter items. The generation-specific pieces are what to establish first, because covers, blade sets and down-rods from a later Millat may not fit an earlier one.
Fans & Air Coolers in stock now
Our current fans & air coolers, across all brands — ask us on WhatsApp if you want Millat specifically.
Like NewAir Cooler
Like NewHaier
Like NewAir Cooler
Good UsedLahori Cooler
Checking a used Millat fans & air cooler
These are specific to Millat. The general fans & air coolers checks apply too and are on the fans & air coolers page.
Sight along the blade set
Blades from another generation or another fan bolt straight on but differ in pitch and weight. Stand under it and look for one tip sitting lower than the rest, then check that all the blade castings carry the same markings.
Match capacitor to the plate
Ceiling fan labels usually list the capacitor value in microfarads. Compare it with what is actually fitted in the switch box or canopy, because an oversized capacitor is the standard way of making a tired winding spin and it runs the motor hotter.
Run it at full speed
Leave it on the top setting for twenty minutes and put a hand on the motor housing. A rewind with the wrong turns count runs hotter and slower than the original, and that is how you separate a good rewind from a bad one.
Rock a blade arm
Take hold of one arm and try to lift and rock it. Vertical play means worn bearings or sleeve bushes in a motor that has run a very long time, and it shows up as a hum and a wobble at speed rather than as an outright failure.
What Millat fans & air coolers are worth
- An untouched or correctly rewound Millat that reaches full speed without heating holds value, because running temperature is the one thing a buyer can use to judge a decades-old fan on the spot.
- Mismatched blades cost more in the grade than a scratched body, since a fan on a mixed set wobbles from the first rotation and cannot be corrected without a matched set.
- Die-cast Millat bodies survive long enough that even a non-runner keeps value as a rewind candidate rather than falling out of the market.
General fans & air coolers checks
These apply whatever the badge on the front says — the fans & air coolers page covers them in full.
Spin the blades by hand
With the power off, turn the blades. A healthy fan coasts several turns and stops smoothly. A gritty feel, a rumble or a rotor that drags means dry or worn bushes, and a fan run in that state will cook its winding within a season.
Feel the motor housing
Run it on full for fifteen to twenty minutes, then put a hand on the housing. Warm is normal. Too hot to hold, or a smell like burnt varnish, means the winding is going. That smell never clears, and rewinding a domestic fan seldom repays what it costs.
Watch for wobble
Start a ceiling fan and watch the canopy. Wobble usually comes from a bent blade arm, mismatched blades or a loose down-rod rather than from the motor. Sight along each blade for a bend and check the mounting holes in the arms for elongation, which is what makes a fan impossible to balance afterwards.
Test the start
A fan that hums but only turns once you nudge a blade has a weak capacitor. It is an inexpensive part, but it should be found before money changes hands. Step through every regulator position too: a dead speed points at the regulator or a broken winding tap rather than at the capacitor.
Watch the cooler pads wet
Fill an air cooler's tank, switch the pump on and look at the top of the pads. Water should spread across the whole width within a minute. Dry stripes mean a blocked distributor pipe or a weak pump. Honeycomb pads that have collapsed or gone crusty with salt need replacing before the machine will cool at all.
Press the cooler tank
Push the sides of the water tank and inspect the drain plug and base corners. Plastic that has stood in the sun goes chalky and brittle, and hairline cracks there open up as soon as the tank is full. While you are there, spin the blower wheel by hand for bearing noise and work the swing louvre through its travel.
Millat fans & air coolers — questions
Is an old Millat ceiling fan worth rewinding?
Why does my used Millat fan wobble at speed?
Other fans & air coolers brands
Selling one instead? We buy used Millat fans & air coolers for cash.